Aodyo Instruments

    Aodyo Community

    • S'inscrire
    • Se connecter
    • Récent
    • Catégories
    • Recherche

    midi out huge delay/ latency with new sync unit

    Sylphyo General
    4
    5
    1078
    Charger plus de messages
    • Du plus ancien au plus récent
    • Du plus récent au plus ancien
    • Les plus votés
    Répondre
    • Répondre à l'aide d'un nouveau sujet
    Se connecter pour répondre
    Ce sujet a été supprimé. Seuls les utilisateurs avec les droits d'administration peuvent le voir.
    • K
      k0872 dernière édition par

      thanks new upgrade arrived today, has lots of potential, very few sounds to start but all work well

      I am noticing though that midi out has now much worse delay/ latency than the panda receiver.

      especially with breath control output, using the new sync its all fine, but using the sync to midi out to vl 70m I am getting huge delay? very hard to use.

      I hav elooked at breath settings but all seem fine, and what is puzzling it works fine via headphones and your sounds but not via midi out.

      same cables unit etc as when I was using the panda

      1 réponse Dernière réponse Répondre Citer
      • join
        join dernière édition par

        The MIDI output should not have latency. This could be due to a problem in the configuration of your Sylphyo. Please try the following things:

        • disable Dynamic Velocity (set it to 127)
        • decrease the rate of the breath MIDI messages (higher rates are known to cause issues with old synths like the VL70m, depending on your playing style) in the settings menu > MIDI Mapping > Breath More Options > Breath Rate (set it to Low or Very low)
        • perform a Factory reset (in the Settings menu)

        If you have another MIDI synth handy, could you please check that it behaves similarly with respect to latency? If not, then something must be off in the configuration of your VL70m. If you still have problems we'll try to find a VL70m and set it up to reproduce your issue.

        R&D Engineer at Aodyo / Ingénieur R&D chez Aodyo

        1 réponse Dernière réponse Répondre Citer
        • R
          randybrown dernière édition par

          I just received the Sylphyo and Link yesterday. This morning I tested playing an iPad via MIDI. I used an iConnectMIDI MIO with its MIDI DIN plugs plugged into the back of the Link and the other end plugged into the iPad.

          I made no settings change to how the Sylphyo and Link came from Aodyo.

          I tested several synths I have installed and all performed with no noticeable lag.

          1 réponse Dernière réponse Répondre Citer
          • K
            k0872 dernière édition par

            I had all those settings, but did a factory reset which seems to have solved the latency

            I am wondering if setting additional breath parameters adds latency.

            adding aftertouch and bc2?

            1 réponse Dernière réponse Répondre Citer
            • L
              Laurent_AODYO dernière édition par

              We didn't achieve the factory reset on upgraded Sylphyo to avoid changing our user setup. This seems to have been the issue.

              Adding extra MIDI parameter can add latency due to additional MIDI messages (and MIDI low baudrate), but only at the last MIDI conversion level (either on the Sylphyo USB MIDI or on the Link MIDI DIN or USB output).

              1 réponse Dernière réponse Répondre Citer
              • 1 / 1
              • Premier message
                Dernier message
              Copyright © 2015 NodeBB Forums | Contributors

              Il semble que votre connexion ait été perdue, veuillez patienter pendant que nous vous re-connectons.