For the record: the Sylphyo mentioned above was returned to Aodyo for a checkup. I got it back in March, and while the functional issues were solved, there was still a problem with the fit of the outer casing: the upper half of the bell doesn't quite match the bottom. Bax has sent me another Sylphyo as a replacement, which appears to work fine. It has the same problem with the bell though.

Update after some days of trying about 8 earlier software versions on both Sylphyo and Link: no change. The Link is stuck in pairing mode. Since my intended workflow relies on using outboard sounds, I will go back to the store, so they can decide what to do.

Once more, the Sylphyo got into a state of discharge. I regularly connected it to a computer yesterday and only left it switched on without USB connection for under 10 minutes today. The battery indicator showed about 3/4 full, no warning. I think I have to give up on this unit.

Since the update to 1.4.7, the Sylphyo won't respond to the command to actively search for an available Link. Has anyone been succesful?

Best regards, Chris

Thank you for your reply Maxence. Is the battery indicator supposed to ever reach the top? 4177 mV is the max value in Diagnostics after over 48 hours of charging.

Aaah, that clarifies things, thank you! I wish this info was in the manual and in the FAQ. I only used the Sylphyo for short periods of time. The instrument worked normally until I switched it off. Then the next time it wouldn't power up. I have never seen the message that you need to charge. Someone mentioned an auto shut-off when charge gets too low. That would be an elegant solution.

Hi, I have been trying out a Sylphyo for two weeks. it's a B-stock, and according to the battery indicator was fully charged on arrival. Two times it ran out of power completely, and it took about 24 hours of charging for the Sylphyo to regain life. I tried using different cables and chargers. Any advice for things to try?

Best regards, Christian