Can't trigger the same note twice in a row after sending CC2
-
I just got mine delivered today, and tried a few patches, so far just with a keyboard, but I'm able to send CC2.
After the first time I send CC2, I am no longer able to play the same note twice in succession - it only sounds the first time. To play the same note again, I have to play a different note first.
I haven't yet found out how to check what firmware version I have, and I don't see it in the manual, so perhaps this has been addressed already?
-
@andyhornblower said in Can't trigger the same note twice in a row after sending CC2:
how to check what firmware version I have,
Shift then turn the main encoder will give you a menu which allows you to select diagnostics. Right at the top of the diagnostics screen is the firmware revision.
It also flashes up very briefly during power-up.
-
@bibenu Thanks... It seems to be Click, then turn, to see Diagnostics. I hadn't noticed it on power up. It seems to be shown below the logo, but barely long enough to register on my retinas.
On trying the new editor version, from the 0.8.90 zip download, I was told I needed to update it, so I'm now on the newest firmware version and didn't see what version it was on initially, before I did that.
However, the same thing still happens.
To be clearer, it's on the percussive patches. If I turn it on, then play those without sending CC2, it works fine, but as soon as I send CC2 I get the problem - no note can be played twice in a row on the percussive patches, even if I switch to a different patch and back again. That persists until I turn the anyma off and back on again.
That's going to cause problems if I try to play those patches with a wind controller, and there doesn't seem to be any reason why I couldn't, other than that bug.
