Hello everybody,
I am using Sylphyo v.01 (no internal sounds, no Link) as a MIDI controller to control hardware synths - mostly Moog Sirin, sometimes Dreadbox Typhon.
I have as bought in 2019 and worked like a charm for almost two years until one day receiver just died. I have sent it back to Aodyo, they have either repaired or got me a new receiver - and everything seemed to be fine for a month or so when another problem appeared. Some MIDI notes stick and play infinitely or until I play that very note again. The problem appears when i use Sylphyo with hardware synths, so i tried to connect it as MIDI controller in VST - when receiver is connected to a PC (MIDI over usb) - and it was the same problem there. I have tried to reset Sylphyo to factory setting many times - the problem was still there. I have changed the MIDI cables - nothing. I tried to turn off rotation and elevation etc - still the same. I have tried to lower breath rate - still nothing. Adjusted note-off delay - nothing, messed with Breath minimums, etc - nothing. Cleaned Sylphyo - nothing... I have updated the firmware - nothing. Even tried to downgrade to older firmware to check if it will work - still the same. It is quite annoying as i can not play normally and summer festival bookings are getting closer.
I have written a couple of mails to Aodyo Support but got no answer. Maybe some of you can help with some advice before i send it back for another repair? I am not sure if i am doing something wrong with the settings or the instrument (or receiver) is faulty.
Thanks a lot in advance! Please help!
Milan
p.s. this is how it looks like in VST: