@andyhornblower said in Where to found more longer power cable ??:

"1M Right Angle Male to Female 2.1mm x 5.5mm DC Extension Lead Connector".

That appears to be listed on amazon too, so thank you.

@support_aodyo said in No signal via midi OUT:

This is something that we could work on in a future software update if there is interest.

I would be interested in that as an option.

@deepsea said in How to remove a mapping?:

how to remove a specific mapping from a patch (other than just neutralizing its impact by setting the amount to 0).

Set the ‘from’ of the mapping to ‘none’.

@andyhornblower said in Planned time-line:

Now we just need somewhere better to put them all together in one place.

Agreed. What do you think @Support_AODYO ?

@bibenu said in Planned time-line:

I'm very much in favour of one place to find user-contributed patches. Either

One thread (perhaps pinned ?) in the Anyma Phi section of the forum, or perhaps even a sub-forum of Anyma Phi General (similar to Early Adopter Lounge) ... either one of those.
Or get a new section set up on say https://www.presetpatch.com or https://patchstorage.com/

@markusschloesser I'd agree, that seems like a reasonable enhancement. One that's used on other hardware too, so it's not like it would be difficult for people to learn.

@andyhornblower said in Planned time-line:

Maybe I just don't have the privileges yet, because I only registered yesterday?

I get the same problem ... I've been here a couple of weeks now ... :shrug:

I'm hoping that Aodyo give us clear pointers to a preferred method (which they've done already) that works (the privileges problem) . I know there are other ways to share, but it could get messy keeping track if we all go our own way.

@andyhornblower said in Planned time-line:

@join Is there a section specifically for sharing patches in, or do we just put them in any thread?
It would be good to keep them together in one place, if possible.

I'm very much in favour of one place to find user-contributed patches. Either

• One thread (perhaps pinned ?) in the Anyma Phi section of the forum, or perhaps even a sub-forum of Anyma Phi General (similar to Early Adopter Lounge) ... either one of those.
• Or get a new section set up on say https://www.presetpatch.com or https://patchstorage.com/

The 'one thread' option assumes that the 'privileges' problem found by @AndyHornBlower is solved of cousre, and that we can upload patched ourselves.

@andyhornblower said in Renaming a patch doesn't stick (v0.8.90, updated today):

I thought maybe shift+right arrow, on the synth, was needed to make the change permanent,

I’m pretty sure I’ve done exactly that to make an edit permanent. Might have been on the 8.80 firmware though.

@andyhornblower said in Can't trigger the same note twice in a row after sending CC2:

how to check what firmware version I have,

Shift then turn the main encoder will give you a menu which allows you to select diagnostics. Right at the top of the diagnostics screen is the firmware revision.

It also flashes up very briefly during power-up.

@milododds said in Trying to Update the Anyma Phi. Not able to connect the Anyma Phi to my Macbook Pro laptop, suggestions?:

might there be a shift button on the Anyma Phi?

There is a shift button on the Anyma Phi and that's the one you need. It's at the bottom of the vertical strip of 6 buttons, labelled like a shift button on a mac keyboard.

I've been through this a couple of times and it has worked fine.